Home/Alternatives/Ports & terminals
The alternative to Kpler for Ports and Terminals
Most ports open a maritime data search with one of the large maritime analytics platforms. That is a sound starting point. This page addresses what follows. We are an independent AIS data provider operating its own network, and we merit a place on the same shortlist.
100,000+
Vessels tracked / day
49M+
AIS positions / day
40+
Countries covered
<5s
Antenna to your API
Who we are, and how our data is actually built.
We collect the data on receivers we own, none of it bought in or blended from third party feeds.

AIS data for ports is our entire businessWorldwide AIS Network ApS is a Danish company based in Copenhagen, CVR 45911748, backed by Den Danske Maritime Fond, approved under the Startup Denmark scheme, and building with peaq. Ports, terminals and harbour authorities are the whole of our market.
We operate our own networkTerrestrial and ship-borne receivers, plus satellite feeds for open ocean, across 40+ countries: 100,000+ vessels tracked a day and 49M+ positions a day. Every station runs identical standardised hardware, encrypting each message at the instant of capture. Every position is nanosecond time-stamped and carries a trust score from our anomaly detection models.
Delivery is deliberately conventionalRaw NMEA over TCP for a VTS that treats us as another receiver, a REST API for reporting and analysis, a WebSocket stream for live traffic, and SAPIENT compliant output to the BSI Flex 335 interface, under five seconds from antenna to your API.
Benchmark us against your current supplySend the polygon covering your approaches. We will return the positions our network collects inside it, with receiver metadata and trust scores attached.
See live data for your portWhat to look for in an AIS data provider for ports and terminals.
These are the questions we would put to a supplier from your side of the table. Ask them of everyone on your shortlist, including us. If another provider answers them better for your port, that is the correct outcome.

Provenance: a single message either traces to its receiver or it does not.
Select one position from a delivery and ask which receiver collected it, and at what time. Some products are built to deliver a clean vessel track and are designed around that; others can resolve a track back to the underlying messages. Neither is wrong, but a port that may have to defend a port call time, a demurrage position or an incident reconstruction should establish which it is buying before the question arises. We keep the collection record attached, because our own network collected it.
Latency: figures are comparable only when the measurement points match.
Antenna to API, API to your screen, and the refresh interval of a map view are three separate numbers, and each vendor quotes the one that favours it. Require every provider to define both endpoints, then measure it live against your own approaches at a busy hour rather than accepting the published figure. Ours is under five seconds from antenna to API.
Delivery formats: one format rarely serves VTS, the PMIS and the port community system.
VTS and traffic display work require raw NMEA and AIVDM over TCP, reporting and traffic studies require a REST API and a bulk history export, live dashboards require a WebSocket stream, and sensor fusion or counter-UAS work requires SAPIENT compliant output to the BSI Flex 335 interface, the BSI-published specification for SAPIENT, the sensor and effector architecture owned by the UK MOD. Establish what you receive if you need raw rather than processed output, and whether it is charged separately.
Coverage: headline global figures say nothing about your own approaches.
Global figures, ours included, describe almost nothing about a specific port. VHF is line of sight, roughly 20 to 40 nautical miles, and dense port traffic causes message collision, so what determines value is reception across your approaches, the roadstead, the pilot boarding place and the berth pockets. Issue every provider the same polygon and the same date range, request the raw result rather than a coverage map, and establish how far back the history for that area extends.
Ownership of the receivers determines continuity of the feed.
Establish who owns them. Commercial AIS supply has consolidated into fewer owners, so a feed licensed today may sit inside a different group at renewal, which is a tender and continuity question for a port before it is a technical one. Confirm what happens to your terms if ownership changes, and settle redistribution within the port community in writing, so terminals, agents and the pilot service are not each licensing the same positions.
Spoofing and interference: a doubtful position is flagged or silently removed.
GNSS jamming and AIS spoofing introduce false positions and phantom port calls into the operating picture, and the material difference between products is whether a doubtful position arrives with an indicator attached or is smoothed away before you see it. Establish whether the assessment travels with the data into your own systems. We assess the validity of every position and pass that through rather than deciding on your behalf.
How we produce the data
your port would be buying.
Every station runs the same dedicated, standardised hardware, encrypting each message at the instant of capture.
Collect
On receivers we own
Terrestrial and ship-borne receivers, plus satellite feeds for open ocean, run by us rather than licensed from somebody else, covering 100,000+ vessels a day across 40+ countries, including the approaches and roadsteads where a port actually needs reception.
Verify
Scored before it reaches you
Each position is nanosecond time-stamped and given a trust score by our anomaly detection models, so a manipulated position is flagged rather than written into your port call record.
Deliver
Into the systems you already run
Raw NMEA over TCP, a REST API, a WebSocket stream, or SAPIENT compliant output to BSI Flex 335, in under five seconds from antenna to your API. You keep your VTS, your PMIS and your berth planning exactly as they are.
How Worldwide AIS Network compares.
The questions to put to every provider on your shortlist, including us.
| What to check | What to ask any provider | Worldwide AIS Network |
|---|---|---|
| Where the data comes from | Do you operate the receivers yourselves, or buy and blend feeds from others? | Our own independent physical infrastructure. Terrestrial and ship-borne, plus satellite feeds. |
| Provenance on each position | Can you tell me which receiver collected this specific position, and when? | Every position carries its originating receiver and a nanosecond time stamp. |
| Handling of spoofing | How do you detect a manipulated or spoofed position before it reaches me? | Anomaly detection models assess the validity of every position in real time. |
| Latency | What is the delay from reception to the data being available in my system? | Under five seconds, antenna to API. |
| Delivery formats | Which formats do you deliver, and will they drop into what I already run? | Raw NMEA over TCP, REST API, WebSocket stream, and SAPIENT compliant output to BSI Flex 335. |
| Coverage where it matters to you | Can you show me real data for my specific waters before I commit? | 100,000+ vessels a day across 40+ countries. Ask for a sample of your own area. |
| Running alongside what you have | Can I add you next to my current provider rather than replacing it? | Yes. Running side by side is the intended pattern, not a compromise. |
We have deliberately not filled in a column for any other provider. Coverage, latency and sourcing change, and a claim we cannot evidence is worth nothing to you. Put these questions to everyone you are evaluating and compare the answers yourself.
Questions we get from ports comparing providers.
Can we run Worldwide AIS Network alongside our existing provider?
Yes, and that is the expected pattern rather than a concession. Two independent sources over the same water is how a disagreement between them gets resolved, and for a port it also removes a single point of failure in the feed contract. Most engagements begin as a second source alongside something already in place, and many remain that way. We would rather run beside your current supply and be assessed on the overlap than ask a harbour master to withdraw a working system on trust.
How much integration work is a second AIS feed, realistically?
It depends where the feed lands. If your VTS or traffic display already ingests raw NMEA and AIVDM over TCP, we present as another receiver and the work is configuration rather than development. If it enters a PMIS, a data warehouse or a reporting stack, the effort is normally mapping our fields to an existing schema and deciding how to reconcile two sources for the same vessel. Budget for a parallel run and a reconciliation pass rather than a same day cutover. We will say so at the outset if we consider your case the harder kind.
If we did switch, do we have to move everything at once?
No, and we would advise against it. The sound sequence is a sample for your port polygon first, so it can be reconciled against records you already trust, then a live feed running in parallel through a busy period, then a decision on what moves and what stays. Nothing in our delivery requires exclusivity, so the point at which you consolidate, if you do at all, remains your decision rather than ours.
Do you cover our port, and how do we check?
Send a polygon and we will answer precisely, including where we are thin. We supply only what our own network collected, never a feed bought in from somebody else. Our network covers 40+ countries, but that is a headline figure and your port is a specific body of water, so ask for the raw result for your own approaches rather than a coverage map. Where we cannot serve the requirement, we will say so before you commit rather than after.
Are you a replacement for a full maritime analytics platform?
These are two different purchases and should be assessed as such. We are a data provider: our product is verified AIS position data with its provenance attached, delivered as raw NMEA, a REST API, a WebSocket stream or SAPIENT compliant output, into whatever your port already runs. If the requirement is a workflow product with screens, alerts and analyst tooling built in, evaluate that separately. A platform and an independent data source are not mutually exclusive. Ports operate both.
Past the comparison stage?
This page is written for evaluation. If the requirement is settled and you want the detail on port call measurement, anchorage waiting time, berth occupancy, screening a caller before committing a berth, and traffic measurement for capacity and dredging work, the main page for the sector goes considerably deeper: AIS data for ports and terminals.
AIS data for ports and terminalsComparing providers for another sector?
Put us on the shortlist and test us.
Send the port area. We will return the positions our network collects there, the origin of every message, and where our coverage is thin, so the comparison rests on data rather than on claims.
See live data for your port


